Smart Technologies SMART Board 800i5-SMP - Manual (Page 32)

Setting Use Notes
Location Displays the projector’s location as set
by an administrator (maximum 16
characters). You can set the projector’s location
using the remote management features
(see Remotely managing your system
through a network interface on page 61
and Remotely managing your system
through an RS-232 serial interface on
page 71).
Contact Displays the contact name or number
for projector support as set by an
administrator (maximum 16
characters). You can set the contact name or
number using the remote management
features (see Remotely managing your
system through a network interface on
page 61 and Remotely managing your
system through an RS-232 serial
interface on page 71).
Language menu
Language Selects language preference. Projector menu support is available in
English (default), Chinese (Simplified),
Chinese (Traditional), Czech, Danish,
Dutch, Finnish, French, German,
Greek, Italian, Japanese, Korean,
Norwegian, Polish, Portuguese
(Brazil), Portuguese (Portugal),
Russian, Spanish and Swedish.
Information menu
Lamp Hours Displays the current number of lamp
usage hours from 0 to 4000 hours from
when it was last reset. Always reset the lamp hours after you
replace a lamp, because lamp service
reminders are based on the current
hours of use. See Resetting the lamp
hours on page 43 for details on the
lamp hours reset procedure.
Input Displays the currently displayed video
input source (VGA-1, VGA-2,
Composite, S-Video, HDMI or
None).
Resolution Displays the projector’s most recently
detected video source signal resolution
and refresh rate. If there is no current video input source
signal, this setting displays the last
known source signal image resolution
and refresh rate.
Firmware Version Displays the projector’s digital display
processor (DDP) firmware version in
x.x.x.x format.
C H A P T E R 3
Using your interactive whiteboard system
20