Smart Technologies Smart board Interactive Whiteboard system 400iv - Manual (Page 69)

The following table describes the source selection commands:
Command Description
get input Returns the projector’s current input.
set input [field] Returns the input to one of the selectable fields.
The following table describes the source selection response fields:
Field Description
VGA1 Switches source to the VGA 1 input connector.
Composite Switches source to the Composite video connector.
S-Video Switches source to the S-Video input connector.
None A non-selectable value that appears when you enter a “get input”
command while the projector is in Standby mode.
General source controls
The following source controls apply to all input sources. These controls are unavailable when the
projector is in Standby mode. You can specify custom color values for all inputs.
These commands inform you of the current source settings.
Command Response
get displaymode displaymode=[current display mode setting]
get brightness brightness=[current brightness setting]
get contrast contrast=[current contrast setting]
get whitepeaking whitepeaking=[current whitepeaking setting]
get degamma degamma=[current degamma setting]
get red red=[current red color setting]
get green green=[current green color setting]
get blue blue=[current blue color setting]
get cyan cyan=[current cyan color setting]
get magenta magenta=[current magenta color setting]
get yellow yellow=[current yellow color setting]
get videofreeze videofreeze=[current video freeze setting]
A P P E N D I X A
Remotely managing your interactive whiteboard system
59