Projector lights and status – Smart Technologies Smart board Interactive Whiteboard system 400iv User Manual
Page 47
Projector lights and status
Two indicator lights (Power and Service) are located on the bottom of the SMART V25 projector.
Specific light sequences convey information about the state of the projector, including errors.
I
I M P O R T A N T
After you resolve the projector’s issue, disconnect and then connect the projector power cable to
clear the indicator light sequence, and then reset the projector’s status (see Resetting the projector
Power light
Service light
Message
Solid red
Off
The projector is off but still receiving power (Standby
mode). Press the Power
button on the remote control to
turn it on.
Flashing green
Off
The projector is in the powering (startup) power state. Wait
for the projector to finish turning on.
Solid green
Off
The projector is in the operating (on) power state. Press the
Power
button on the remote control twice to turn it off.
Flashing red
Off
The projector is in the cooling power state. Wait for it to
finish cooling.
Off
Flashing red
The projector is overheating. It could shut down
automatically.
See The “Projector Overheated” message appears on next
page to troubleshoot the projector.
C H A P T E R 6
Troubleshooting your interactive whiteboard system
37