Suzuki XL7 - Manual (Page 233)

5-49
SERVICE AND APPEARANCE CARE
78J00-03E
• For solid dry soils: remove as much as
possible and then vacuum.
To clean, use the following instructions:
1) Saturate a lint-free, clean white cloth
with water or club soda.
2) Wring the cloth to remove excess mois-
ture.
3) Start on the outside edge of the soil and
gently rub toward the center. Continue
cleaning, using a clean area of the cloth
each time it becomes soiled.
4) Continue to gently rub the soiled area
until the cleaning cloth remains clean.
5) If the soil is not completely removed,
use a mild soap solution and repeat the
cleaning process that was used with
plain water.
If any of the soil remains, a commercial
fabric cleaner or spot lifter may be neces-
sary. When a commercial upholstery
cleaner or spot lifter is to be used, test a
small hidden area for colorfastness first. If
the locally cleaned area gives any impres-
sion that a ring formation may result, clean
the entire surface.
After the cleaning process has been com-
pleted, a paper towel can be used to blot
excess moisture from the fabric or carpet.
Leather
A soft cloth dampened with water may be
used to remove dust. If a more thorough
cleaning is necessary, a soft cloth damp-
ened with a mild soap solution can be
used. Allow the leather to dry naturally. Do
not use heat to dry. Never use steam to
clean leather. Never use spot lifters or spot
removers on leather. Many commercial
leather cleaners and coatings that are sold
to preserve and protect leather may per-
manently change the appearance and feel
of your leather and are not recommended.
Do not use silicone or wax-based prod-
ucts, or those containing organic solvents
to clean your vehicle’s interior because
they can alter the appearance by increas-
ing the gloss in a non-uniform manner.
Never use shoe polish on your leather.
Instrument Panel, Vinyl, and Other
Plastic Surfaces
A soft cloth dampened with water may be
used to remove dust. If a more thorough
cleaning is necessary, a clean soft cloth
dampened with a mild soap solution can
be used to gently remove dust and dirt.
Never use spot lifters or removers on plas-
tic surfaces. Many commercial cleaners
and coatings that are sold to preserve and
protect soft plastic surfaces may perma-
nently change the appearance and feel of
your interior and are not recommended.
Do not use silicone or wax-based prod-
ucts, or those containing organic solvents
to clean your vehicle’s interior because
they can alter the appearance by increas-
ing the gloss in a non-uniform manner.
Some commercial products may increase
gloss on your instrument panel. The
increase in gloss may cause annoying
reflections in the windshield and even
make it difficult to see through the wind-
shield under certain conditions.
Care of Safety Belts
Keep belts clean and dry.
Weatherstrips
Silicone grease on weatherstrips will make
them last longer, seal better, and not stick
or squeak. Apply silicone grease with a
clean cloth. During very cold, damp
weather frequent application may be
required. Refer to “Recommended Fluids
and Lubricants” in “Maintenance Sched-
ule” in the “Maintenance Schedule” sec-
tion.
Washing Your Vehicle
The paint finish on the vehicle provides
beauty, depth of color, gloss retention, and
durability.
WARNING
Do not bleach or dye safety belts. If
you do, it may severely weaken them.
In a crash, they might not be able to
provide adequate protection. Clean
safety belts only with mild soap and
lukewarm water.