Sharp UX-D50 - Manual (Page 81)

Remote Operations
79
3. Ans
w
er
ing
Machi
n
e
Other remote operations
After listening to your messages, you can perform any of the following
operations by pressing the appropriate keys on the telephone.
Note: The following commands cannot be entered while messages are being
played back. If you do not want to wait until playback ends to enter a
command, first stop playback by pressing and , and then enter the
command.
Changing the fax reception mode
Select a new reception mode by pressing the keys as follows:
0
♦
A.M. mode: , , and .
♦
FAX mode: , , and .
♦
TEL mode: , , and .
Caution: If you select TEL mode, you will not be able to change the
reception mode again.
♦
TEL/FAX mode: , , and .
8 1
8 2
8 3
8 4
Recording a new outgoing message
1
Press and on the telephone.
2
When you hear a short beep, speak into the telephone to record the new
message.
•
The message can be up to 15 seconds long. After 15 seconds (or earlier if
the machine detects silence after you finish speaking), you will hear a beep,
and the new message will be played back.
4
all.book Page 79 Monday, September 1, 2003 3:46 PM