Sharp UX-D50 User Manual
Page 76
Transfer Function
74
6
Each time the machine receives an incoming message, it will call your
programmed transfer number. When you answer, you will hear your
recorded message telling you that the call is a transfer call. On the dial
pad of your phone, enter
, your remote code number (see page 75),
and
. The machine will play back your messages.
•
You can also perform any of the remote operations described in Remote
Operations later in this chapter (see page 75).
Note: When you hang up after a transfer call, the machine will not
immediately resume normal operation. If you want the machine to accept calls
immediately after a transfer call, enter
twice before hanging up (if you
want to hang up during message playback, first enter
and
to stop
playback, then enter
twice).
0
all.book Page 74 Monday, September 1, 2003 3:46 PM