Sirius Satellite Radio SPORTSTER 5 User Manual
Page 59
[
Installation
]
59
Step 7: Optimize the placement of the FEA
Mute the volume of your Sportster SP5. The easiest way to do this is to use the
M
UTE
button on the remote control (see pages 67 – 68). Note, your SIRIUS radio
is still ON.
Turn up the volume of your vehicle’s FM radio. If you hear static or interference
adjust the position of the FEA until the static or interference is eliminated or
minimized (see Figure 42).
If the level of static or interference is still high, please select another FM channel
by repeating Steps 5 & 6, on pages 56 – 57.
Step 8: Permanently install the FEA
Note: If you are mounting the FEA in the vehicle’s headliner, skip this step.
When you are satisfi ed with the FEA’s mounting location, remove the suction cup mounts
and peel the backing off the bead and arrow adhesive mounts. Clean the area where the
FEA will be attached with the alcohol swab. Permanently adhere the FEA in the same
position on the glass (or A-pillar), making certain the wire is taut and is as straight as
possible (see Figure 43). If necessary, use the cable guides to hold the cable.
1.
2.
3.
Figure 43
REMOVE
ADHESIVE BACKING
FROM ARROW
REMOVE
BOTH SUCTION CUPS
USE THE CABLE GUIDES TO HOLD THE CABLE
IN POSITION UNTIL IT REACHES
THE INNER TRIM OR MOULDING
REMOVE
ADHESIVE BACKING
FROM BEAD
THIS THINNER PORTION OF THE FEA
SHOULD BE TAUT WHEN THE FEA
IS PERMANENTLY ADHERED
Figure 42