Smart Technologies Smart Board 2000i - Manual (Page 6)

2 Projector Replacement Guide for the 2000i 99-00496-00 REV A0
5. With another person supporting the projector, reach through the view port and remove the
three nuts (including the steel and nylon washers) that secure the projector in place and then
remove the projector. Use the provided 7/16" nut driver to loosen the nuts. Keep the nuts and
washers nearby, as you’ll need them when you install the new projector in step 8.
Remove these nuts and washers
CAUTION Be very careful not to lose the spring and nylon shoulder washers on the long
screw as you remove the projector from the cabinet. See the figure below for
the location of this hardware.
Nylon Washers and Spring