Sharp AR-287 - Manual (Page 9)

1-5
CHAPTER
1
POWER ON AND OFF
The power switch is located on the left side of the copier. When the
power switch is turned to the “ON” position, the message “
WARMING
UP. PLEASE WAIT. ” will appear in the message display. Warming
up takes about 65 seconds for the AR-287/337 and about 75 seconds
for the AR-407. Once the copier is ready, the message display will
change to “
READY TO COPY.
”, and the START key indicator will light
up, indicating that copying is possible.
If the copier has been programmed in the auditing mode, the message
“
ENTER YOUR ACCOUNT NUMBER. -----
” will appear after warming
up. Once a valid account number has been entered, copying will
become possible.
Power save modes
The copier has two power save modes to reduce overall power
consumption and thereby reduce the cost of operation and to conserve
natural resources to help reduce environmental pollution. The two
power save modes are preheat mode and auto power shut-off mode.
★ KEY OPERATOR
The preheat activation time and the auto power shut-off time have been
preset at the factory to 15 min. for preheat mode and 60 min. for auto
power shut-off mode. These times can be changed as described in the key
operator’s guide. It is suggested that you set appropriate times according
to the actual usage of the copier.
GETTING STARTED
Power on and off
Power on
Power off