Sharp AR-287 - Manual (Page 50)

3-16
CHAPTER
3
4 Indicate whether the insert sheets are copied on or not.
● Select “YES” or “NO” on the touch panel.
5 Press the upper “OK” key.
6 Load transparency film into the bypass tray.
7 Ensure that the desired tray is selected for insert sheets.
● The copy paper for insert sheets must be the same size as the
transparency film.
8 Make all other selections and press the START key.
● If the document feeder is used, scanning of originals and copying
will start.
● If the document glass is used in the SORT mode, proceed to the
next step.
9 Replace the finished original with the next original after
the START key indicator lights up, and then press the
START key. Repeat this step until all originals have been
scanned. Then, press the “READ-END” key on the touch
panel.
● Copying will start at this time.
● Up to 120 sheets of 8-1/2" x 11" originals or up to 60 sheets of
originals larger than 8-1/2" x 11" can be scanned.
● When copying is completed, remove remaining transparency
film.
● To cancel the TRANSPARENCY INSERTS function, select the
TRANSPARENCY INSERTS function again and press the
“CANCEL” key.
TRANSPARENCY FILM WITH INSERT SHEETS
SPECIAL FUNCTIONS
Transparency film with insert sheets
PAPER SELECT
100%
COPY RATIO
AUTO 8/ 11 1
2
1.8/ 11
2.11 17
1
2
8/ 11 1
2
ORIGINAL
8/ 11 1
2
C
CLEAR
INTERRUPT
CA
CLEAR ALL
START
PRINT ON THE INSERT
SHEETS?
YES
NO
CANCEL
OK
OK
OK
OK
THE INSERT
AUTO
EXPOSURE PAPER SELECT
100%
COPY RATIO
READ-END
PLACE NEXT ORIGINAL. PRESS [START].
WHEN FINISHED, PRESS [READ-END].
AUTO 8/ 11 1
2