Sharp AR-287 - Manual (Page 7)

1-3
CHAPTER
1
CAUTIONS
1. Do not touch the photoconductive drum. Scratches or
smudges on the drum will cause dirty copies.
2. The fusing unit is extremely hot. Exercise care in this area.
3. Since a hard disk drive is built into the copier, be sure to turn the
power switch to the “OFF” position when moving the copier. Take
care not to subject the copier to any vibration or shock.
4. Do not look directly at the light source. Doing so may
damage your eyes.
5. Four installation adjusters are provided on the optional
stand/500-sheet paper drawer.
When moving the machine with the optional stand/500-
sheet paper drawer, be sure to raise the installation adjusters.
After moving the machine, lower the four installation adjusters
until they reach the floor and lock the two casters at the front
of the copier.
6. When copying is interrupted (for example, because the
INTERRUPT function has been used, paper or toner has run out,
a misfeed has occurred, etc.), this copier will store the image
data of the originals read prior to the interruption. If copying of
secret documents is interrupted due to the above reasons, be
sure to either resume the interrupted copying by pressing the
START key, or clear the image data by pressing the CLEAR ALL
key after the interrupt copying is completed or the trouble is
cleared, because the stored data may be printed by other
operators.
“BATTERY DISPOSAL”
CONTAINS MANGANESE DIOXIDE LITHIUM BATTERY.
MUST BE DISPOSED OF PROPERLY. CONTACT YOUR
SHARP DEALER OR SERVICER FOR INSTRUCTIONS.
GETTING STARTED
Cautions
Fusing unit
Photoconductive
drum
Lock Release
Adjuster
Lock
Caster
Release