Star Micronics LC-8211+ User Manual

Page 74

❏

While holding down the control panel’s

and

LINE

buttons, turn the

printer back on to enter the Dot Adjustment Mode.
The printer will print something like the following.

Note that the printer will feed the paper forward and back each time during
this operation so you can view the printout.

❏

If the two lines do not align properly, use

FONT

to move the lower line to

the left or

MODE

to move it to the right.

The above step performs alignment for Normal-density mode only. You
must make separate adjustments for the CRT graphics mode I, DRAFT
Text, DRAFT Graphics, Double-density, CRT graphics mode II, Triple-
density, Quadruple-density, LQ Text and LQ Graphics modes as well.

❏

Press

to change to another printing mode.

❏

Repeat the above steps for each printing mode, if necessary.

❏

After making changes to the adjustments, press

ON LINE

to exit the Dot

Adjustment Mode and register your adjustments.

***

DOT ADJUSTMENT SETTING

***

Normal-density