Star Micronics LC-8211+ - Manual (Page 11)

4 Printer Setup
Removing the protective materials
Protective sheets and a piece of cardboard are inserted into the printer to protect
components during shipping. Before using the printer, be sure to remove all
packing material from inside the front cover as shown in the illustration.
Installing the platen knob
The platen knob is packed into a recess in the packaging material.
❏
Install the knob on the shaft located inside the large hole on the right side of
the printer. Make sure that the flat side of the shaft is aligned with the
corresponding flat surface inside the knob’s spindle. Press the knob
carefully but firmly into place as far as it will go.
Cardboard
Front cover
Protection sheet