Sony LBT-XG500 - Manual (Page 24)

24
Do This
Press FUNCTION repeatedly
until “PHONO” appears.
1 Remove the jumper from
the unit.
2 Connect the SEND jack of
the unit to the IN jack of the
mixer with an optional
cable.
3 Connect the RETURN jack
of the unit to the OUT jack
of the mixer with an
optional cable.
4 Press FUNCTION
repeatedly until “CD”
appears.
Connecting a turntable/
mixer
(mixer for European, North
American, and Mexican models only)
To
Listen to the
connected turntable
Listen to the
connected mixer
To the outputs
of your mixer To the audio outputs
of your turntable To the inputs of
your mixer
Tips
You can also record the sound produced by the mixer
onto a tape.
Notes
• Using a turntable at high volume may cause
distortion or howling. This is often caused by the
bass sound from the speakers. The bass sound may
produce the distortion or howling. To avoid this, do
the following:
1 Keep some distance from speakers and the
turntable.
2 Stop using the surround effect.
3 Install the speakers or the turntable on a firm and
stable surface.
4 Press SUPER WOOFER repeatedly until the
indicator on this button goes off.
• Replace the jumpers when the mixer is not in use.
Otherwise, no sound will be heard. Be sure to
connect the jumpers from the RETURN jack to the
SEND jack of the unit.
Two jumpers are pre-installed connecting the DJ
MIX RETURN and SEND jacks.