Sony LBT-XG500 - Manual (Page 17)

17
Tape
To
Check the setting
Cancel timer
operation
Notes
• The system turns on 15 seconds before the preset
time.
• If the system is on at the preset time, the Timer
recording will not be made.
• When you use the Sleep Timer, Daily Timer and
Timer recording will not turn on the system until
the Sleep Timer turns it off.
• Recording starts from the front side.
Do this
Press TIMER SELECT. Press
v/V to select “SEL REC.”
Then, press ENTER/NEXT. To
change the setting, start over
from step 1.
Press TIMER SELECT. Press
v/V to select “TIMER OFF.”
Then, press ENTER/NEXT.
Timer-recording radio
programs
To timer-record, you must preset the radio
station (see “Presetting radio stations” on page
12) and set the clock (see “Setting the time” on
page 8) beforehand.
1
Tune in the preset radio station (see
“Listening to the radio” on page 13).
2
Press c /CLOCK SET.
3
Press v / V repeatedly to select “REC,”
then press ENTER/NEXT.
“ON” appears and the hour indication
flashes in the display.
4
Set the time to start recording.
Press v/V to set the hour, then press
ENTER/NEXT.
The minute indication starts flashing.
Press v/V to set the minute, then press
ENTER/NEXT.
The hour indication flashes again.
5
Set the time to stop recording following
the above procedure.
The start time appears, followed by the stop
time, the preset radio station to be recorded
(e.g., “TUNER FM 5”), then the original
display appears.
6
Insert a recordable tape into deck B.
7
Turn off the power.
When the recording starts, the volume level
is set to the minimum.
Recording a CD by specifying
track order
— Program Edit
When programming, make sure the playing
times for each side do not exceed the length of
one side of the tape.
1
Load CDs and a recordable tape into
deck B, then press FUNCTION
repeatedly until “CD” appears.
2
Press PLAY MODE repeatedly until
“PROGRAM” appears.
3
Select a CD and track by pressing DISC
SKIP and turning the jog dial, then
press PLAY MODE once.
Repeat this procedure to program the
remaining tracks for A side.
4
Press X on the remote to insert a
pause at the end of side A.
“P” appears and the total playing time resets
to “0.00” in the display.
5
Repeat step 3 to program the remaining
tracks to be recorded on side B.
6
Press CD SYNC.
Deck B stands by for recording.
7
Press DIRECTION repeatedly to select
g to record on one side.
Select j (or RELAY) to record on
both sides.
8
Press X .
Recording starts.
9
Press x on the deck B and the CD
player to stop recording.
Tip
To check the required tape length for recording a CD,
press EDIT so that “EDIT” flashes after you have
loaded a CD and switched function to CD. The
required tape length for the currently selected CD
appears, followed by the total playing time for side A
and side B respectively (Tape Select Edit).
Notes
• You cannot use Tape Select Edit for discs
containing over 20 tracks.
• You cannot use this function when Program Play
mode has been set. After clearing the entire
program, follow the above procedure.