Schneider Electric Modbus Plus Network Bridge Multiplexer none - Manual (Page 91)

Installing the BM85 31007492 81
5.5.2 Serial Port Parameters Label
On this label enter the parameters you are using at each of the serial
ports. Place the label on the BM85 so that it can readily identify the
parameters in your application.
Figure 24 shows the layout of the label.
MODBUS PORT 1 PORT 2 PORT 3 PORT 4
MASTER / NTWK /
SLAVE (ADDRESS)
ASCII / RTU
BAUD RATE
STOP BITS / PARITY
TIMEOUT (100’S ms)
MODEM BOOSTER
Figure 24 Serial Port Parameters Label