Sony Video Projector VPL-VW90ES - Manual (Page 57)

57
U
s
in
g t
he M
e
n
u
s
Screen Menu
The Screen menu is used to adjust the input signal. You can adjust the size of the picture,
and select wide screen mode, etc.
.
These items may not be available, depending on the type of input signal. For details, see “Input
Signals and Adjustable/Setting Items” (
1 pages 89 to 92).
Note
Wide Mode
(Video signal) You can set the aspect ratio of the picture to be displayed for the
current input signal. (
1 page 35) This item is enabled only when a
video signal (preset memory numbers 1 to 14) ( 1 pages 86, 86) is
input.
Wide Zoom: A 4:3 aspect ratio picture is enlarged naturally to fill the
screen. The upper and lower portions of the screen are slightly cut off.
Normal: A 4:3 aspect ratio picture is displayed in the center of the
screen and enlarged to fill the screen vertically.
Full: A picture squeezed to 4:3 aspect ratio is displayed in its original
aspect ratio. When a 4:3 aspect ratio picture is displayed, the picture is
enlarged horizontally to fill the 16:9 screen.
Zoom: A picture is enlarged vertically and horizontally in the same ratio
to fill the screen. The upper and lower portions are cropped.
Anamorphic Zoom: A 2.35:1 aspect ratio picture is converted to a
normal 16:9 picture on the screen. This mode is best suited when
using a commercially available Anamorphic lens which converts a
normal 16:9 aspect ratio picture to a 2.35:1 picture
(1 pages 8, 36).
If you set “Trigger Select” on the Installation menu to
“Anamorphic Zoom,” 12 V signals will be output from the TRIGGER
connector (
1 page 64).
You can switch settings by pressing WIDE MODE on the remote
control.