Sony KL-50W1 - Manual (Page 11)

11
GB
FURTHER PROGRAMME PRESET
PROG
1
2
3
4
5
6
7
8
9
10
Select and press OK
ATT
0
0
- 1
- 1
0
- 1
- 1
- 1
- 1
- 1
VOL
on
on
on
on
on
on
on
on
on
on
IN-AMP AFT
on
on
- 1
- 1
on
- 1
- 1
- 1
- 1
- 1
off
off
off
off
off
off
off
off
off
off
Using “Further Programme
Preset”
Using the menu “further Programme Preset” you can
a) in case of a strong local aerial signal (striped picture) attenuate the
signal individually for each programme position (RF attenuator).
b) individually adjust and store the volume level of each channel
(Volume offset).
c) in case of a strong sound signal (distorted sound), attenuate the
sound signal for each programme position.
d) use the manual fine tuning to obtain a better picture reception, if
the picture is distorted. Normally the AFT (automatic fine tuning) is
operating.
1 Press MENU to display the main menu.
2 Select the symbol for “Preset” with
>
+ or
?
– and press OK.
The PRESET menu appears.
3 Select “Installation” with
>
+ or
?
– and press OK. The
INSTALLATION menu appears.
4 Select “Further Programme Preset” with
>
+ or
?
– and press OK.
The FURTHER PROGRAMME PRESET menu appears (See Fig.
17).
5 Using
>
+ or
?
– select the desired programme position and press
OK once to select a) “ATT” (RF Attenuator), twice to select b)
“VOL” (Volume offset), three times to select c) “IN-AMP” (Input
Amplifier) or four times to select d) AFT (Automatic Fine Tuning).
The selected item changes colour.
To adjust or change:
a) RF attenuator (ATT)
Using
>
+ or
?
– select “On” for the selected programme position.
Press OK to confirm the selection. Repeat step 5 to attenuate
other programme positions.
b) Volume offset (VOL)
Using
>
+ or
?
– you can adjust the volume level for the selected
programme position within a range form –7 to +7.
Press OK to store the volume level.
Repeat step 5 to set the volume level for other programme
positions.
c) IN-AMP (input amplifier)
Using
>
+ or
?
– select “Off” for the selected programme position.
Press OK to confirm the selection. Repeat step 5 to switch off the
input amplifier for other programme positions.
d) AFT
Using
>
+ or
?
– you can fine-tune the channel within a range from
–15 to +15. Press OK to store the fine-tuned level. Repeat step 5
to fine-tune the other channels.
6 Press MENU to return to the normal TV mode.
INSTALLATION
To reactivate AFT
(Automatic Fine
Tuning)
Repeat from the
beginnig and select “ON”
in step 5.
Fig. 17