Sanyo TLS-224P - Manual (Page 21)

RECORDING USING AN EXTERNAL
TIMER INPUT
Recording can be controlled by an external start/stop
signal input at the EXT TIMER IN terminal.
Example 2: To record using the signal input at
the EXT TIMER IN terminal, in
12-hour mode.
NOTE:
•
External timer input recording can only be set on the
9th line (“EXT”) of the (TIMER SET) menu.
1
Follow steps 1 to 3 under “PROGRAMME TIMER
RECORDING” on page 17.
2
Press the ] button, until “EXT” (External) setting is
flashing.
° The “SPD” (recording speed) position will start
flashing.
3
Press the l (or j ) button to select the recording
speed (ex: 12), then press the « button.
° “N” will start flashing.
4
Press the l (or j ) button to select “Y”.
5
Follow steps H and I under “PROGRAMME
TIMER RECORDING” on page 17.
° When an external signal is input, “E” will light
on the digital display and recording will take
place.
NOTES:
•
Other timer recordings using the standard procedure
can also be programmed.
•
When there is a signal being input at the EXT TIMER
IN terminal, “E” will be displayed on the digital display
and recording is conducted.
WEEK START STOP SPD
SUN --:-- --:-- --- N
MON --:-- --:-- --- N
TUE --:-- --:-- --- N
WED --:-- --:-- --- N
THU --:-- --:-- --- N
FRI --:-- --:-- --- N
SAT --:-- --:-- --- N
DLY --:-- --:-- --- N
EXT ¤¤¤¤¤ ¤¤¤¤¤ --- N 9th line
WEEK START STOP SPD
SUN --:-- --:-- --- N
MON --:-- --:-- --- N
TUE --:-- --:-- --- N
WED --:-- --:-- --- N
THU --:-- --:-- --- N
FRI --:-- --:-- --- N
SAT --:-- --:-- --- N
DLY --:-- --:-- --- N
EXT ¤¤¤¤¤ ¤¤¤¤¤ 12 Y
GB
NE4QG/EX (TLS-224P GB) Mon. May, 11/1998
20 English