Sanyo TLS-224P - Manual (Page 10)

CHANGING THE ON-SCREEN DISPLAY
Selecting the On-screen Display
You can select to display or not the date, time, the
number of alarm triggers and tape speed.
1
Turn the power on to all devices used.
2
Press the AUDIO ON/MENU button until the (SET
UP 2) menu is displayed.
3
Press the ] button, until the desired item for which
the display function will be set is flashing.
4
Press the l (or j ) button to set “Y” for the
functions described below.
DATE . . . . . . . . . . The date is displayed
TIME . . . . . . . . . . . The time is displayed
ALARM COUNT . . The number of alarm
triggers is displayed
SPEED . . . . . . . . . The recording/playback
speed is displayed
5
Press the PAUSE/SCAN button, the normal screen
is displayed.
° The setting procedure is now completed.
NOTE:
•
If the ON SCREEN switch is set to the “ON” position,
the items for which “Y” is set are recorded. The items
for which “N” was set at step
4 above are not
recorded.
Changing the Date/Time Display
Position
1
Turn the power on to all devices used.
2
Set the ON SCREEN switch to the “ON” position.
° The date and time are displayed.
3
Press the « (or ] ) button.
° The display will move towards the right (or the
bottom).
NOTES:
•
If the « (or ] ) button is kept pressed for 1 second or
more the display will move at a faster speed.
•
The display position cannot be changed while
recording.
öDISPLAY
DATE Y
TIME Y
ALARM COUNT Y
SPEED Y
öBUZZER
ALARM IN Y
TAPE END Y
KEY IN N
Date/Time display
15-10-99 FRI 000
15:20:00 24
GB
NE4QG/EX (TLS-224P GB) Mon. May, 11/1998
English 9