Sub-Zero 424/O - Manual (Page 33)

33
A N C H O R T H E U N I T
After door and side panels have been installed,
the unit has been leveled and door adjustment
completed, anchor the unit to the opening.
This will assure a proper fit and a secure
installation. The Sub-Zero Anchoring Kit (part
#4200900), available from your Sub-Zero
dealer, includes the necessary hardware.
IMPORTANT NOTE: Be sure to level and
square the unit before anchoring it.
T W O U N I T S A N C H O R E D T O G E T H E R
Drill three 13 / 64 " holes through the middle
trim of both units.
Using the Loctite on the screws, install the
three Chicago screw posts.
Recheck the units for level.
Drill three 3 / 16 " holes through both outer
trims. Refer to illustration 15 below.
Using a 1 / 8 " drill bit, drill into the cabinetry
for a pilot hole.
Install all six Sems to the cabinetry.
U N I T A N C H O R E D T O C A B I N E T R Y
First, make sure units have been leveled
and aligned, and doors adjusted.
Drill three 3 / 16 " holes through both outer
trims. Refer to illustration 16 below.
Drill a 1 / 8 " pilot hole into the cabinetry.
Install all six Sems.
Illus. 15 Illus. 16
Do not drill through the model and serial
number plate.
M O D E L 4 3 0 I N S T A L L A T I O N I N S T R U C T I O N S
M O D E L 4 3 0
O P T I O N A L
C O M P O N E N T S
Optional installa-
tion components
are available
through your
Sub-Zero dealer,
or call Sub-Zero at
800-222-7820.
You can also visit
our website at
subzero.com.