Sony VPL-BW5 - Manual (Page 40)

40
• Press APA when the full image is displayed on the screen. If the projected image includes a black
portion around it, the APA function will not work properly and some parts of the image may not
be displayed on the screen.
- You can cancel the adjustment by pressing APA again while “Adjusting” appears on the screen.
- The picture may not be adjusted properly depending on the type of input signal.
- Adjust the “Dot Phase,” “H Size,” and “Shift” items in the INPUT SETTING menu when you
adjust the picture manually.
• If the input signal is not displayed correctly when “Input-A Signal Sel.” is set to “Auto,” set it to
conform the input signal.
Color System Selects the color system of the input signal.
If you select “Auto,” the projector detects the color
system of the input signal automatically. If the
picture is distorted or colorless, select the color
system according to the input signal. Auto
Power Saving Selects the Power Saving mode.
Lamp off: The lamp goes off if no signal is input for
10 minutes. The lamp lights again when a signal is
input or any button is pressed.
Standby: The projector goes into Standby mode if
no signal is input for 10 minutes. To use it, turn on
the power again.
Off: The projector does not go into Power Saving
mode.
Off
IR Receiver Selects the remote control detectors (IR Receiver)
on the front and rear of the projector.
Front & Rear: Activates both the front and rear
detectors.
Front: Activates the front detector only.
Rear: Activates the rear detector only.
Front & Rear
Lamp Timer
Reset When replacing the lamps, reset the lamp timer. –
Notes
Setting items Functions Initial setting