Sony HT-DDW5500 - Manual (Page 32)

32 GB
1
Press AMP MENU.
2
Press AUTO CAL.
Measurement starts in 5 seconds and the
display changes as follows:
A.CAL [5]
t A.CAL [4] t A.CAL [3]
t A.CAL [2] t A.CAL [1]
While the time is counting down, stand
away from the measurement area to avoid
measurement error.
3
Measurement starts.
The measurement process will take a few
minutes to complete.
The table below shows the display when
measurement starts.
* The corresponding speaker indicator lights
up in the display during measurement.
4
Measurement ends.
“COMPLETE” appears on the display
and the settings are registered.
After you have finished
Disconnect the optimizer microphone from the
AUTO CAL MIC jack.
Notes
• Auto Calibration cannot detect the subwoofer.
Therefore, the subwoofer settings will be
maintained.
• If you have changed the position of the speakers, it
is recommended that you perform Auto Calibration
again to enjoy the surround sound.
• You cannot select Auto Calibration when the
headphones are connected.
Tips
• When Auto Calibration starts:
– Stand some distance away from the speakers and
the listening position to avoid measurement
failure. This is because test signals are output
from the speakers during measurement.
– Avoid making noise to get a more accurate
measurement.
• The Auto Calibration function will be canceled
when you do the following during the
measurement process:
– Press ?/1 or MUTING.
– Press the input buttons or turn the INPUT
SELECTOR on the receiver.
– Change the MASTER VOLUME level.
– Connect the headphones.
– Press AUTO CAL again.
Performing Auto Calibration
1 2 3
4 6
7 8
0/10 ENTER
9
SYSTEM STANDBY
TV INPUT
SLEEP DMPORT
VIDEO1 VIDEO2 BD DVD
2CH A.F.D.
TV CH –
PRESET –
TV CH +
PRESET +
MOVIE MUSIC
AMP MENU
CLEAR
DISPLAY MUTING
TV VOL
MASTER VOL
DVD/BD
MENU
AUTO CAL
D.TUNING
D.SKIP
SAT TV SA-CD/CD TUNER
?/1
. < < >
5
REPLAY ADVANCE
MEMORY
O
RETURN/EXIT
>10/
-/--
TV ?/1
AV ?/1
TOOLS/
OPTIONS
MENU/HOME
Input
buttons
?/1
switch
MUTING
MASTER
VOL +/–
AUTO
CAL
AMP
MENU
Measurement for Display
Environment noise
level NOISE.CHK
Speaker connection MEASURE and SP
DET. appears
alternately*
Speaker level MEASURE and GAIN
appears alternately*
Speaker distance MEASURE and
DISTANCE appears
alternately*