Sterling Plumbing Pivot Shower Doors SP1500D Series - Manual (Page 2)

Tools and Materials
Before You Begin
CAUTION: Risk of personal injury. Always wear safety glasses when cutting materials.
IMPORTANT! Pay special attention to the section titled ″Very Important Instructions.″ Failure to follow
the directions could result in product damage.
IMPORTANT! This shower door is designed to be specifically paired with a Sterling shower module. Do
not install this shower door if you do not have a Sterling shower module installed.
IMPORTANT! Record the model number on the Homeowners Guide if you intend to save it, or in your
records for later use. The proper model number will enable our customer service representatives to quickly
help you if needed.
NOTE: When using a retractable case tape measure, add the length of the case to the measurement or
measure in a manner that excludes the case.
Your new Sterling door can be installed with the door opening to either the right or left. Install the
door with the pivot side away from the showerhead for best results.
Before starting the installation, lay out and identify all of the parts. Inspect them for damage.
Closely follow the instructions pertaining to the sealant application on the door. Sealing areas other
than those shown may cause leaking.
Two people should perform this installation.
Sterling reserves the right to make revisions to the design of products without notice, as specified in
the Price Book.
Safety Glasses Drill
Level
Caulk Gun
Silicone
Sealant
Tape
Measure Claw
Hammer
Pencil
Masking Tape
• Drop Cloth
Plus:
Center
Punch
File • Petroleum Jelly Scissors
Phillips
Screwdriver
Miter Box
Miter Saw or Hack Saw with
32-teeth Per Inch Blade
1034026-2-D 2 Sterling