Sony SPP-A2770 - Manual (Page 17)

Getting Started
17 US Getting Started
Entering the area code
When you use this phone for the first time, or move to an area that has a
different area code, you must enter the area code. Otherwise, you cannot use
some functions of this phone and the Caller ID functions.
This is also necessary because the phone must be able to select an area code to
properly dial a call from the Caller ID list.
Depending on your region, enter the 3-digit area code as follows:
Case 1.
If 7-digit dialing (no area code) is accepted for local calls in your area, see “To enter
your home area code” below.
If you live in an area where calls from or to other local areas can also be made by 10-digit dialing
(area code + number), you can register up to 5 local area codes with this telephone to take
advantage of this system. See “To enter the local area code (For 10 digits phone number users)”
on page 19.
Case 2.
If 10-digit dialing (area code + number) is required for all local calls in your area, see
“To enter the local area code (For 10 digits phone number users)” on page 19.
Entering the area code is only possible on the cordless handset. Make sure the base
unit* is not in use before you start the setting. You cannot set the dialing mode while
the system is in use.
* If the system includes additional cordless handsets, it is necessary to stop using them before
you start the setting as well.
To enter your home area code
1
Press (PGM).
2
Turn Jog Dial to choose “AREA
CODE”, and then press Jog Dial.
3
Press Jog Dial again.
“ENTER HOME AREA
CODE” appears on the display.
Step 5
(ERASE)
(GO BACK)
HOME :
LOCAL 1:
RING OFF MASSAGE OLD NEW
ENTER
HOME AREA CODE
_
RING OFF MASSAGE OLD NEW
continued
Turn Press