Shindaiwa TRIMMER T242X - Manual (Page 14)

14
Hold the trimmer so the trimmer head
is angled slightly into the area to be
cut. To ensure maximum trimmer-line
service life, cut only with the tip of the
trimmer line. Cut grass by swinging
the trimmer from left to right. Keep the
trimmer head horizontal.
Edging
Tilt the handle
about 100° to
the left (from
horizontal) and
move forward,
holding the
trimmer vertically
as shown.
Your Shindaiwa unit may be equipped
with one of several Shindaiwa trimmer
head models, each with features for
specific applications and/or operational
requirements.
NOTE:
For proper operation, always refer to
the instructions accompanying the
trimmer head being used. Available
trimmer head styles include:
n
Semi-automatic. Trimmer line is
indexed when the operator taps the
trimmer head on the ground during
operation.
n Manual. The operator indexes line
manually with the grass trimmer
stopped.
n Fixed. The operator must stop the
unit and add new lengths of trimmer
line manually.
n Flail. This device, designed for
clearing weeds and light brush,
features three nylon blades attached
to the head by pivots.
NOTE:
Additional hardware may be required
to mount the Fixed Line or the Flail
type trimmer heads.
Cutting Grass—Units equipped with a trimmer head
CAUTION!
Operation at low RPM can lead to
premature clutch failure.
Trimming and
Mowing Grass
CAUTION!
Operation of trimmer without a
cutting attachment shield and using
excessive line length can lead to
premature clutch failure.
CAUTION!
Do not push the rotating line into
trees, wire fences or any material
that could tangle or break line ends.
Engine Operating Speeds
Operate the unit at full throttle while
cutting grass.
Operation
WARNING!
Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from
all openings. Always stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop
before removing obstructions, clearing debris, or servicing unit.
WARNING!
Engine exhaust IS HOT, and contains Carbon Monoxide (CO), a poison gas. Breathing CO can cause uncon-
sciousness, serious injury, or death. Exhaust can cause serious burns. ALWAYS position unit so that exhaust is directed
away from your face and body..
WARNING!
Operation of this equipment may create sparks that can start fires. This unit is equipped with a spark arrestor
to prevent discharge of hot particles from the engine. Metal blade use also can create sparks if the blade strikes rocks,
metal, or other hard objects. Contact local fire authorities for laws or regulations regarding fire prevention requirements.