Sierra Wireless PINPOINT X HSUPA - Manual (Page 36)

Inputs, Relay Outputs, and Power Status
Rev 4.0 Oct.09 30
Note: The Pin-Out diagram shows external view looking at PinPoint X
connector in front face-plate of device. Pin 1 is lower right.
Analog Inputs
Connect a wiring lead to an analog input (AIN) at 1, 3, 12 or 14,
and the nearest ground at 2 or 13.
Digital Inputs
Connect a wiring lead to a digital input (DIN) at 9, 11, 20, or
22, and the nearest ground at 8, 10, 19, or 21, as applicable.
Caution: Never apply voltage to the Digital inputs. The inputs can
only be switched open or closed to ground.
Relay Outputs
Connect the circuit leads to one of the two relay pairs at 6 and
7 or at 17 and 18.
Monitoring and Setting the I/O
You can monitor the status of both the digital and analog
inputs using ACEmanager or AT Commands and also with
special reports sent using RAP. In ACEmanager, select the I/O
group.
You can monitor the status of the relays or set them using
ACEmanager, I/O group, or AT Commands.
Getting Immediate Reports Using RAP
You can set up the PinPoint X to report immediately report the
state of an input when it changes by using *PPFLUSHONEVT.
You will also need *PPINPUTEVT, input event reports,
enabled and a server configured for your RAP reports. These
settings are in the PinPoint group in ACEmanager.
Power Modes and Information
The PinPoint X can be configured to switch power modes in
response to specific events, such as when the voltage to the
modem drops below a configured threshold or when the DTR
changes, in order to conserve a vehicleʹs battery life. The stand‐