4 sound settings (j4, j5, j2), 5 wake-on-lan connector (jp44), 6 cmos clear jumper (jp5) – SOYO SY-5S User Manual

Page 39

Hardware Setup

SY-5STM

2-4 SOUND SETTINGS (J4, J5, J2)

The onboard audio features of your mainboard are controlled by

jumpers J4, J5, J2.

Choose the available sound options among the following table:
Sound Settings

Onboard Sound: Enable *

open* open*

Onboard Sound: Disable

short

Microphone: Stereo *

short*

Microphone: Mono

open

* Starred items refer to default settings.

2-5 WAKE-ON-LAN CONNECTOR (JP44)

Attach the 3-pin connector from the LAN card which supports the

Wake-On-LAN (WOL) function to the JP44 connector on the

mainboard. This WOL function lets users wake up the connected

computer through the LAN card.

Please install according to the following pin assignment:

2-6 CMOS CLEAR JUMPER (JP5)

Clear the CMOS memory by momentarily shorting pin 2-3 on jumper

JP5, and then by shorting pin 1-2 to retain new settings. This jumper

can be easily identified by its white colored cap.

CMOS Clearing

Clear CMOS Data

Retain CMOS Data

(Default)

JP5 Setting

Short pin 2-3 for
a few seconds to
clear the CMOS

Short pin 1-2
to retain new
settings

Note: You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.

Wake-On-LAN

JP44 Pin Assignment

GND

SENSOR