Sunfire TGR401 - Manual (Page 25)

User's Manual
25
3 1
6 4
9 7
2
EXIT
ENT +10
CH VOL
MUTE PREV
CH
MENU
INFO
GUIDE
MAIN
FAV
OFF ON
PAGE
SEL
5
8
0
CHAPTER 3
Remote Control
The TGR-401 remote control is
many remotes in one. There are ten
device buttons, ¿ ve on either side
of the display, and each allows the
remote to operate one piece of equip-
ment.
From the factory, the device buttons
on page 1 are labeled: HD/BD, SAT,
DVR, MP3, DVD, CABLE, VCR, CD,
ZONE2, and TG401.
Only the TG401, ZONE2 and MP3
buttons are pre-programmed, and
these allow the remote to operate your
TGR-401, Zone 2 and the optional
VIA!migo iPod dock. The remote can
be set to operate your other remote
controlled equip ment. This is done in
three ways from the hidden SETUP
menu:
1. Entering a code from the tables at
the end of this manual
2. Stepping through the codes
3. Learning from your other remotes
See Remote Setup on page 27 for
more details.
LCD Display
The top line shows the present
device, mode or status, and it shows
when a remote command is being
transmitted. The bottom line shows
the page number, status and basic
in struc tions during programming.
The main part of the display shows
the labels of the ten device buttons.
You can change any label and cus-
tomize the remote to ¿ t your sys tem.
Note: this is not a touch-sensitive
screen, just a way of labeling the
device buttons on each side, and
showing in struc tions and status.
Contrast
The contrast of the display can be
changed by holding down the MAIN
button and pressing the navigation
pad UP or DOWN.
Light
The button on the right side of the
remote brieÀ y turns on the lights for
the buttons and display. Pressing it
again will turn it off. The number of
sec onds can be varied, or it can be
disabled.
Device Buttons
Once you press a device button,
all the device buttons change label
and function to become buttons to op-
erate your device. There are multiple
pages per device, and you can move
be tween them using the PAGE button.
PAGE
Use this to jump to various display
pages. For example, if you press the
TG401 device button, the display
chang es to show buttons that control
your TGR-401. If you press PAGE, the
display will move to page 2, showing
more func tions for the TGR-401.
MAIN
This button will return the remote
display back to the Main menu.
Depending on which mode you are
in, it may take two or more presses.
This will help you get back to the Main
menu if you get lost in the menus.
FAV
This button allows you to step
through ¿ ve display pages of your
favorite TV and radio stations. These
can be set and re-labeled to suit.
Navigation Pad
This pad and surrounding buttons
are used to operate standard DVD
menus, and VCR and Tape transport
controls. In TGR-401 mode, if you
press MENU, the On Screen Display
will appear and the navigation buttons
can be used to select and adjust the
various items.
LIGHT
MAIN
Navigation
Batteries
The remote takes four AAA bat-
teries inside the rear compartment.
These should last about six months
in normal use, before a low-battery
warning appears.
LCD
DEVICE
Buttons
DEVICE
Buttons
PAGE
IR WINDOW
FAV