SECO-LARM USA Delayed Egress Timer SA-025EQ - Manual (Page 8)

ENFORCER Delayed Egress Timer
8 SECO-LARM U.S.A., Inc.
Remote Alarm Relay Output:
 The SA-025EQ is equipped with a 10A@24VDC Form C dry relay output for a
remote alarm.
 The remote alarm relay is normally energized. The onboard screen print refers to the
energized state as normal.
 A remote alarm connected to this output will begin signaling at the start of the
pre-delay timer.
 The remote alarm will continue signaling until the door is relocked.
 In the event of power loss, the remote alarm relay will de-energize to trigger the
remote alarm.
 The remote alarm will signal when the pre-delay bypass is activated.
 The remote alarm will also signal during free egress if the door is left open longer than
5 seconds (door status jumper must be ON for this to occur).
 LED 3 (red) is on when the remote alarm relay is energized.
Local Alarm Output:
 The SA-025EQ is equipped with a 500mA@12VDC transistor ground output for a
local alarm.
 The local alarm output can be set for steady or pulsing by changing jumper 3 (see pg. 7)
 LED 4 (red) is on when the local alarm output is active.
Lock Relay Output:
 The SA-025EQ is equipped with a 10A@24VDC Form C dry relay output that can be used
with a fail-safe or fail-secure lock.
 The lock relay is normally energized. The onboard screen print refers to the energized state
as normal.
 In standard mode, the lock relay will de-energize after the pre-delay time expires. The lock
relay will re-energize when the reset input is activated.
 In BOCA mode, the lock relay will de-energize after the pre-delay time expires. The lock
relay will re-energize after a door with a N.C. magnetic contact attached to the lock status
input has been closed for 30 consecutive seconds.
 In timed mode, the lock relay will de-energize after the pre-delay time expires. The lock
relay will re-energize after the post-delay time expires.
 LED 2 (red) is on when the lock relay is energized.
Pre-Delay Bypass Input (N.O.+):
 Connect a N.O. switch between the pre-delay bypass and the positive terminal.
 The pre-delay bypass input bypasses the pre-delay time for immediate egress.
 The remote alarm and local alarm outputs are still active when the pre-delay bypass is used.
 The door will relock according to the relock mode.