Star Micronics SP2000 Series - Manual (Page 34)

– 31 –
ENGLISH
4 Determine the diameter of the roll
paper you are using and find the
required setting in the table below.
Distance A Setting Indicator
Approximate 9 mm Level 3 ooo
Approximate 7 mm Level 2 oo
Approximate 5 mm Level 1 *1 o
*1 Cannot be used with 2 and 3 ply.
Note:
1. Since the distance A correspond-
ing to the adjustment position on
the chart is a calculated value,
there may variations due to the
actual mechanism.
2. If there is an end mark at the end
of a roll of paper, that end mark
is an adhesive that may lift the
entire roll of paper. In such a
case, the remaining roll paper
amount (Distance A) shown in
the chart above will not apply.
3. The quality of some paper may
cause it to become jammed. This
can result in erroneous detec-
tion.
5 Insert the tip of a ballpoint pen or
similar pointer object into the hole
of the adjuster. While pressing the
adjuster, slide it up or down to the
setting you that matches the roll
paper you are using.
6 Make sure the tab indicated by the
arrow in the illustration is inside
one of the grooves.
…
……
………
Level 3
Level 2
Level 1
Fig. 8-3
Roll paper core
ø12 mm
A
ø18 mm
A
Fig. 8-2