Sony STRDG910 - Manual (Page 37)

37 GB
D:\CANNES\SONY_HA\JOB 2007\STR-
DG910\IM_910_CEL\Data_CEL\GB_data\GB03CON_STR-DG910-CEL.fm masterpage: Right
STR-DG910
3-094-430-31 (1)
Getting Star
ted
• CODE 31
1 Press RECEIVER.
The RECEIVER indicator lights up and
receiver operation is activated.
2 Press .
3 Perform the Auto Calibration again (page 35).
• CODE 32, 33
1 Press RECEIVER.
The RECEIVER indicator lights up and
receiver operation is activated.
2 Press .
“RETRY Y” appears on the display.
3 Press again.
4 Perform the Auto Calibration again (page 35).
When you select “WARN CHK”
If a warning on the measurement result is
present, detailed information is displayed.
Press to return to step 2 of
“Confirming/saving the
measurement results”.
When you select “PHASE”
You can check the phase of each speaker (in
phase/out of phase).
Press V/v repeatedly to select a
speaker, then press to return to
step 2 in “Confirming/saving the
measurement results”.
ERROR SR 33 • Either the left or right surround
speakers is not connected.
• Surround back speakers are
connected even though
surround speakers are not
connected. Connect the
surround speakers to the
SPEAKERS SURROUND
terminals.
ERROR SB 33 The surround back speaker is
connected only to the
SPEAKERS SURROUND
BACK R terminals. When you
connect only one surround back
speaker, connect it to the
SPEAKERS SURROUND
BACK L terminals.
Error code Cause and remedies Warning code Explanation
WARN 40 The Auto Calibration has
completed. However, the noise
level is high. You may be able to
perform the Auto Calibration
properly if you try it again, even
though the measurement cannot
be performed in all environments.
Try to perform the Auto
Calibration in a quiet
environment.
WARN 41 The sound input from the
optimizer microphone is out of
range. It is louder than the loudest
sound that can be measured. Try
to perform the Auto Calibration
when the environment is quiet
enough to allow proper
measurement.
WARN 42 The volume of the receiver is out
of range. Try to perform the Auto
Calibration when the
environment is quiet enough to
allow proper measurement.
WARN 43 The distance and position of a sub
woofer cannot be detected. This
may be caused by noise. Try to
perform the Auto Calibration in a
quiet environment.
NO WARN There is no warning information.
continued