Sanyo PLC-WL2503A - Manual (Page 37)

37
Choose Video or S-video by pressing the VIDEO button
or the S-VIDEO button on the remote control or press the
INPUT button on the top control.
Before using these buttons, correct input source should be
selected through Menu operation as described below.
1
2
Input Menu
Input Source Selection (Video, S-video)
Video Input
When video input signal is connected to the
VIDEO jack, select Video.
Video
When video input signal is connected to the S-
VIDEO jack, select S-video.
S-video
 Note:
When the Input Search function is set to On 1 or On 2 in
the Auto setup function, the input signal will be searched
automatically (p.45).
HDMI
ASPECT
Remote Control
VIDEO button
Press the MENU button to display the On-Screen
Menu. Use the Point ▲▼ buttons to select Input and
then press the Point ► or the SELECT button.
Use the Point ▲▼ buttons to select either Video or
S-video and then press the SELECT button.
S-VIDEO button
Video
S-video
Direct Operation
Menu Operation
INPUT button
Top Control
Computer 1
Computer 2 *
HDMI
Video
S-video
* COMPUTER 2 can not be selected when using
the COMPUTER IN 2/ MONITOR OUT terminal
as MONITOR OUT output.