Sherwood R-965 - Manual (Page 33)

ENGLISH
STANDBY POWER ON
MAIN PAGE FAV
MUTE
CH. SET VOL
RETURN
DISP
MI
OSD/MENU
1 STEREO
CH/ ADJUST
2 3
4 5 6
7 8 9
0 ENT
M2 M3
DSP DECODE DSP
RNC-510
or
DOWN UP
CH/
ADJUST
33
Enter the test tone mode.
1
• The volume level of each channel can be adjusted easily with the test tone function.
Note: When speakers are switched off , the test tone function does not work.
Cancel the test tone function.
3
Adjusting each channel level with test tone
• The test tone will be heard from the speaker of each
channel for 2 seconds as follows:
FL C FR SR
Front Left Center Front Right Surround Right
SUB SL ( SC) or ( B L BR)
SUBwoofer Surround Left (Surround Center) (Surr. Back Left Surr. Back Right)
• Depending on the speaker setting(None or No), the
test tone of the corresponding channel is not
available.
• ( ): possible depending on whether the surround back
channel is set to 2 CH or 1 CH.
STANDBY POWER ON
AUD2
SLEEP D/A
DIMM S.A/B
ROOM2 SUR.B
T.TON PURE
OSD PARA.
PAGE1
STANDBY POWER ON
AUD2
SLEEP D/A
DIMM S.A/B
ROOM2 SUR.B
T.TON PURE
OSD PARA.
PAGE1
• Each time this button is pressed, the corresponding
channel is selected as follows:
FRONT-L FRONT-C FRONT-R SURR-R
SUBWOOFER SURR-L ( SURR-C) or ( BACK-L BACK-R)
• Depending on the speaker settings and surround
mode, etc., some channels cannot be selected.
• ( ): possible depending on whether the surround back
channel is set to 2 CH or 1 CH.
Note: When speakers are switched off, only
FRONT-L and FRONT-R channels can be
selected.
At each channel, adjust the level as desired
until the sound level of each speaker is
heard to be equally loud.
2
• You can select the desired channel and adjust its
level with repeating the steps and in
“Adjusting the current channel levels” procedure.
Adjusting the current channel levels
Select the desired channel.
1
• After adjusting each channel level with test tone, adjust the channel levels either according to the program sources
or to suit your tastes.
• If you have performed the CH LEVEL SETUP procedure on the OSD menu, you can memorize the adjusted
channel levels into preset memory(PRESET 1, PRESET 2) and recall the memorized whenever you want.(Refer
to “SETTING THE CH LEVEL SETUP” on page 60.)
STANDBY POWER ON
MAIN PAGE FAV
MUTE
CH. SET
VOL
RETURN
DISP
MI
OSD/MENU
1 STEREO
CH/ ADJUST
2 3
4 5 6
7 8 9
0 ENT
M2 M3
DSP DECODE DSP
RNC-510
CH.
SEL
or