Sherwood R-965 - Manual (Page 12)

8. CONNECTING SYSTEM CONTROL
• Connect this jack to the DIGI LINK jack of the external
Sherwood component that uses the DIGI LINK II or III
remote control system.
9. CONNECTING DC TRIGGER OUTs
• Connect components that need to be triggered by DC
under certain conditions as follows :
• Connect a component to DC TRIGGER OUT 1 jack that
allows DC 12 V to turn on or off when this unit’s power is
turned on or off.
• Connect a component to DC TRIGGER OUT 2 jack that
allows DC 12 V to turn on or off when a specific input
source is selected or not.
• For details, refer to the operating instructions of the
components to be connected.
• To link DC TRIGGER OUT 2 with a specific input source, refer to “When selecting the DC TRIGGER 2 SETUP” on page 55.
Notes :
• This output voltage (12 V d.c., 100mA ) is for (status) control only, it is not sufficient for drive capability.
• When making DC TRIGGER connection, you should use the stereo mini cord, not a mono mini cord.
ROOM 2 connections
• ROOM 2 playback feature allows you to play a different program source in another room as well as one source in the main
room at the same time.
• For ROOM 2 playback, connect the VIDEO 2 / ROOM 2 OUT jacks and the COAXIAL DIGITAL OUT to the amplifier, TV. etc.
installed in another room, or connect the SURROUND BACK speaker terminals to the speakers.
• In case of using a pair of speakers only, you should assign the power amplifier for surround back channels to the ROOM 2.
(For details, refer to “SETTING THE POWER AMP ASSIGN” on page 45.)
Note :
• To minimize hum or noise, use high quality connection cords.
12
ENGLISH
System
control
cord
Sherwood component
with DIGI LINK II or III
CD player
Tape deck
DVD player
1 2
DC TRIGGER OUT
12V d.c. 100 m A
Component to be triggered
by DC when this unit's power
is turned on
Component to be triggered
by DC when a specific input
source is selected
TV or projector
IN
S-VIDEO
IN
VIDEO
(COMPOSITE)
Amplifier
Another room(Room 2) Main room
This receiver
Speakers
AUDIO
IN R
L
COAXIAL
DIGITAL IN
This receiver
Speakers
left right
• When connecting VIDEO 2/ROOM 2 OUTs to the components.
• When connecting SURROUND BACK speaker terminals to
the speakers.