Sharp Electronic Cash Register XE-A505 - Manual (Page 10)

To scan barcodes, connect the included barcode scanner to the cash register.
1. Open the Scanner port cover at the right side of the register.
2. Insert the connector of the barcode scanner into the Scanner port,
and tighten both screws on the connector.
Always unplug the power cord of the cash register when
you connect or disconnect the barcode scanner.
8
GETTING STARTED
Please follow the procedure shown below.
Initializing the cash register
In order for the cash register to operate properly, you must initialize it before operating for the first time.
Follow this procedure.
1. Make sure the power cord plug is not inserted into the AC outlet.
2. Insert the manager (MA) key into the mode switch and turn it to the PGM position.
3. While holding down both the } key and the l key, insert the plug into the
AC outlet. The buzzer will sound three times and “??? MRS. ???” will
be displayed.
4. The cash register has now been initialized. The register display will now
show “0.00” with “PGM”.
If the buzzer does not sound when the plug is inserted, the initialization has not been done
successfully. (This will occur when the voltage is high because you operated the cash register
before starting initialization.) Wait at least ten seconds after pulling out the plug and initialize the
cash register again.
Find a stable surface near an AC outlet where the cash register will not be subject to water sources or
direct sunlight.
Unpack the cash register and make sure all accessories are included. For details of accessories, please refer to
“Specifications” section.
REG
OPX/Z MGR
PGM
X1/Z1
X2/Z2
OFF
VOID
3
Installing the cash register 1
Connecting the barcode scanner 2
PGM
0.00
*** MRS. ***
A505_1 06.6.16 0:38 PM Page 8