Southbend SIMPLE STEAM COUNTERTOP STEAMERS EZ-5 - Manual (Page 5)

M
ODEL
EZ-3 & EZ-5 C
OUNTERTOP
S
TEAMERS
I NSTALLATION
O PERATOR ’ S M ANUAL 1178387 P AGE 5
IN
S
T
A
L
L
A
T
IO
N
I
NSTALLATION
WARNING
DO NOT CONNECT 3/4" ID GREY HOSE IN REAR OF UNIT TO ANYTHING. THESE ARE VENT
HOSES AND MUST BE ALLOWED TO DRAIN INTO PAN. FAILURE TO COMPLY COULD CAUSE
A DANGEROUS PRESSURE RISE INSIDE OF THE STEAMER.
CAUTION
Do not locate unit adjacent to any high heat or grease producing piece of equipment, such as a range
top, griddle, fryer, etc., that could allow radiant heat to raise the exterior temperature of the steam
body above 130°F (54°C). DO NOT MOUNT ABOVE OTHER COOKING EQUIPMENT.
NOTICE
These installation procedures must be followed by qualified personnel or warranty will be void.
Local codes regarding installation vary greatly from one area to another. The National Fire Protection
Association, Inc. states in its NFPA 96 latest edition that local codes are the “authority having
jurisdiction” when it comes to installation requirements for equipment. Therefore, installations should
comply with all local codes.
The unit, when installed, must be electrically grounded and comply with local codes, or in the
absence of local codes with the National Electrical Code ANSI/NFPA 70-latest edition.
Canadian installation must comply with CSA-Standard (C22.2 No. 109-M1981 General
Requirements-Canadian Electrical Code, Part II. 109-M1981) Commercial Cooking Appliances.
Step 1: Unpacking
IMMEDIATELY INSPECT FOR SHIPPING DAMAGE
All containers should be examined for damage before and during unloading. The freight carrier has
assumed responsibility for its safe transit and delivery. If damaged equipment is received, either
apparent or concealed, a claim must be made with the delivering carrier.
Apparent damage or loss must be noted on the freight bill at the time of delivery. The freight bill must
then be signed by the carrier representative (Driver). If the bill is not signed, the carrier may refuse
the claim. The carrier can supply the necessary forms.
A request for inspection must be made to the carrier within 15 days if there is concealed damage or
loss that is not apparent until after the equipment is uncrated. The carrier should arrange an
inspection. Be certain to hold all contents plus all packing material.