Sony DAV-HDZ485 - Manual (Page 27)

27 US
Ge
tting Star
te
d
8
Press C/c to select the speaker
formation image as the speakers are
actually positioned, then press
.
For details, see “Getting Optimal Surround
Sound for a Room” (page 69).
9
Connect the calibration mic (supplied)
to the A.CAL MIC jack on the front
panel.
Set up the calibration mic at ear level using
a tripod, etc. (not supplied).
The front of each speaker should face the
calibration mic, and there should be no
obstruction between the speakers and the
calibration mic.
10
Press C/c to select [YES], then press
.
[AUTO CALIBRATION] starts.
Be quiet during the measurement.
Note
• Loud test sounds are output when [AUTO
CALIBRATION] starts. You cannot turn the
volume down. Give consideration to children
and neighbors.
• Before [AUTO CALIBRATION], install the
surround amplifier in the appropriate location. If
you install the surround amplifier in an improper
location, such as another room, proper
measurement will not be obtained.
• The environment of the room in which the
system is installed may affect measurements.
When the measurements differ considerably
from the status of the speaker installation,
perform the speaker settings manually by
following “Settings for the speakers” (page 54).
11
Unplug the calibration mic, press C/c
to select [YES], then press .
Quick Setup is finished. All connections
and setup operations are complete.
To quit the Quick Setup
Press DISPLAY in any Step.
To recall the Quick Setup display
1
Press FUNCTION +/– repeatedly until
“DVD” appears in the front panel
display.
2
Press DISPLAY while the system is
in stop mode.
The Control Menu display appears on the
TV screen.
3
Press X/x to select [SETUP],
then press .
The options for [SETUP] appear.
4
Press X/x to select [QUICK], then press
.
The Quick Setup display appears.
Calibration mic
9 4 ( 9 9 )
CUSTOM
CUSTOM
DVD VIDEO
T 0 : 0 1 : 0 8
1 ( 1 )
QUICK