Woodstock 6" BENCH GRINDER M1051 - Manual (Page 12)

-10-
M1051 6" Bench Grinder
SET
UP
Test Run
Once your machine is mounted and assembled, you should
perform a test run to make sure it works properly.
To perform a test run, do these steps:
1. Make sure all tools are removed from the grinder
area.
2. Make sure the switch is in the OFF position.
3. Plug the grinder into the power source.
4. Move the switch to the ON position.
• Under normal conditions, the grinder will make a
loud humming noise, with only minor vibration.
• If you hear or see anything unusual with the grinder,
turn it OFF, unplug it, and troubleshoot the cause
the problem. If you CANNOT determine the source of
the problem, call our tech support BEFORE starting
the machine again.
DO NOT investigate problems or adjust
the bench grinder while it is running.
Wait until the machine is turned OFF,
unplugged and the spindle has come
to a complete stop before proceed-
ing!