Charge battery, Getting started, A d g – Siemens S56 User Manual

Page 15

Getting started

S56 am, A31008-H5700-A40-1-7619 (12. May 2003, 17:19)

Siem

ens AG 2002

, I

:\Mob

il\L55\S55_

Mar

lin\am\S56\fug\S5

6L_Sta

rtup

Charge battery

The battery is not fully charged

when delivered. Plug charger cable

into the bottom of the phone, plug

power supply unit into a power sock-

et and charge for at least two hours.

Display when charging is in progress

During charging.

Charging time
An empty battery is fully charged

after about 2 hours. Charging is only

possible in an ambient temperature

of 41 °F to 104 °F (the charge icon

flashes as a warning when the tem-

perature is 41 °F above/below this

range). The voltage specified on the

power supply unit must not be ex-

ceeded.
To obtain maximum performance

from the battery, it must be fully

charged and then emptied at least

five times.

Charge icon not visible
If the battery is totally discharged, no

charge icon is displayed when the

charger is plugged in. It will appear

after a maximum of two hours. In

this case the battery is fully charged

after 3-4 hours.
Only use the charger provided!
Display while in service
Charge level display during opera-

tion (empty-full):

a d g

A beep sounds when the battery is

nearly empty. The battery level is

only shown correctly during an un-

broken charging/discharging cycle.

You should therefore not remove the

battery unnecessarily

and where possi-

ble not finish the loading process early.

Note
The charger heats up when used for long

periods. This is normal and not dangerous.
Performance...............................page 122
Battery quality statement............page 118

Note
Your phone's display is delivered with a protective film.
Remove this film before getting started.
In rare cases, the static discharge may cause discoloration at the edges of the display. How-

ever this will disappear within 10 minutes.