English – SMC Networks SMC7004AWBR User Manual
Page 13
Using the CD
Insert the CD into your CD-ROM drive.
The installation screen will
automatically appear. (If it doesn’t,
please click “Start”, and then “Run…”
Then type
A. To install the print server software: Please refer to section
“Installing and Configuring the Print Server” in this guide.
Note: If you are not connecting your Barricade to a printer,
you do not need to install the print server software.
B. To read the User Guide: Click on “Read User Manual.”
(Note: you must have Adobe Acrobat Reader installed before
viewing the manual. If you do not have it, you can install it
from the CD. To install it, click “Start”, then “Run…”
and type
5. Click the “Details” tab.
6. Under “Print to the
following port:”,
select “PRTmate:
(All-in-1).”
7. Click “Port Settings.”
8. Enter the Barricade IP Address
(default is 192.168.123.254)
and click “OK.”
9. Click “Spool Settings…”
and, if available, select
“Disable bi-directional support
for this printer” and click “OK”
10.Click “OK” to close the printer
details window.
11.Your computer is now configured to print
via the Barricade Print Server. Repeat these steps
on each computer connected to the Barricade.
English
English