Sanyo XACTI HD VPC-FH1GX User Manual
Page 50
29
English
PREPARING THE REMOTE CONTROL UNIT
Changing the remote control code
The remote control unit will also work with other Sanyo cameras that can be
operated by infrared remote control. When more than one camera is present,
it is recommended to change the remote control code to ensure that only the
intended camera operates when the remote control unit is used. The remote
control code is set to “RC CODE 1” at the time of purchase.
1
Aim the infrared emitter at the remote control sensor on the camera.
2
Simultaneously press the MENU button and the [
] button for at
least 3 seconds.
3
Press a button on the remote control unit and check that the camera
is receiving correctly.
h The remote control codes are retained even if the batteries in the
remote control unit or camera are replaced.
h If the remote control codes for the remote control unit and the camera
and do not match, the remote control unit cannot be used to operate
the camera.
1
Aim the infrared emitter at the remote control sensor on the camera.
2
Simultaneously press the MENU button and the [
] button for at
least 3 seconds.