Samson VX2510 - Manual (Page 9)

7
Guided Tour - VX 2500 Rear Panel
5. Effect Send jack - Use this 1/4” unbalanced jack to send low imped-
ance (100 ohm) signal from the Model 2500 to a professional outboard
effects processor such as a reverb, echo, chorus, flanger, or harmonizer
device.* Output level is approximately 0 dB to +4 dB and is post-EQ
and post-compression but unaffected by the setting of the Master
Volume control. You can also use the Effect Send jack to route signal to
an external mixing console or amplifier with an input sensitivity of +4
dB.
6. Speaker outputs - The VX2510 & VX2515 internal speaker system is
connected here.
* In-line effects (such as footpedals) intended for low signal levels should
be placed between the bass and the amplifier Input and not connected
with the Effect Send and Return jacks.
** Note that the settings of the ten-band graphic equalizer will affect a
“Post” Direct Out signal regardless of the position of the front panel In/Out
switch.