SUPER MICRO Computer AS1020S-8 - Manual (Page 64)

6-4
AS1020S-8 User's Manual
Figure 6-2. Removing the Fan Housing
6-4 Drive Bay Installation/Removal
Accessing the Drive Bays
SCSI Drives: Because of their hotswap capability, you do not need to access the
inside of the chassis or power down the system to install or replace SCSI drives.
Proceed to the next step for instructions.
Note: You must use standard 3.5" SCSI drives in the 1020S-8.
CD-ROM/Floppy Disk Drives: For installing/removing a CD-ROM or fl oppy disk
drive, you will need to gain access to the inside of the system by removing the
top cover of the chassis. Proceed to the "CD-ROM and Floppy Drive Installation"
section later in this chapter for instructions.
Note: Only "slim" CD-ROM and fl oppy drives will fi t into the 1020S-8.