Samsung SADPCI-202 User Manual

Page 33

positioner model:

For models fitted with the integrated positioner module, refer to the following instructions for positioner
setup (assuming your dish has already been correctly setup):

At the back of the receiver you will find eight connectors provided for the dish actuator -

M1, M2, SENS, GND:
From your actuator motor you will find four wires – two thick and two thin wires. Connect the two thick
motor wires to M1 and M2, the two thin sensor wires to SENS and GND.

0/12V, GND:
Where applicable, connect a 0/12V LNB switch to these two connectors.

+5V, PULSE, GND:
Where applicable, connect a mechanical polariser to these three connectors.

Positioner setup:
With the receiver in analogue mode, press the
INFO/POS key to enter the positioner menu:

SAT No:
Select between 1-64 satellite positions.
SAT Name:
Displays the satellite name. You may move the cursor
into the name field to edit the satellite name.
SAT STORED:
When SAT STORED = NO, all channels with the same
satellite name will be assigned to this satellite position.
DISH POSITION:
Displays the current dish position.
EAST LIMIT:
You may store the current dish position as the East limits
by moving the cursor here and press STORE.
WEST LIMIT:
You may store the current dish position as the West
limits by moving the cursor here and press STORE.
REALIGN:
If for any reason your dish is out of alignment with the
satellites, use this function to realign all satellites in one
operation instead of realigning the satellites individually.

First select a satellite you wish to realign as
reference.

Move the cursor to DISH POSITION

Move the dish East or West to relocate the
reference satellite.

Move the cursor to REALIGN and press STORE

Now all other satellite positions will be realigned
with respect to the reference satellite.

SAT POSITION

SAT NO

SAT NAME ARAB 2A,3A
SAT STORED NO
DISH POSI (----) 5000
EAST LIMIT

0001

WEST LIMIT

9999

REALIGN

CLEAR LIMITS

UP/DN, LEFT/RIGHT, OK, ESC