System menu – Samsung SADPCI-202 User Manual

Page 31

3. System Menu

LNB INPUT:

Select upto eight LNB settings for your analogue system, A1 to A4,
B1 to B4. You can assign different LNB parameters (local oscillator
frequency, LNB power, 22KHz, 12V and DiSEqC control) for each
LNB setting.
For the selected input set the following:

LOCAL OSC:

Select the appropriate LNB local oscillator frequency.
You can select from 5.150, 9.750, 10.000, 10.750, 11.000, 11.475,
Universal Low Band, Universal High Band, and a variable setting
(between 9.100 to 14.000GHz).

LNB PWR:

Select the LNB power supply. You can select from 14V, 18V and
V/H for Marconi type LNBs including Universal LNBs.

22KHz:

You can select 22KHz ON/OFF to control an external tone switch.
Note: When using a Universal LNB, 22KHz will be used to switch
the LNB and therefore 22KHz will be set to AUTO .

0/12V:

To control an additional 12 volt accessory switch.

Decoder:

The decoder status; from here you can select the type of decoder
de-emphasis required for your decoder.
(PAL,MAC,CLAMP,CANAL+)

COPY:

To copy the settings from exsisting channel’s setting to new
Channel’s one directly.

4. DiSEqC Menu:

SAT POSITION:

Use to select between position A or B of a DiSEqC switch.

SWITCH OPTION:

Use to select between option A or B of a DiSEqC switch.
Note:
The DiSEqC function is enabled in the Installation menu.

DiSEqC:

Turns the DiSEqC control function ON or OFF. Switch this option
ON when you are using DiSEqC controlled equipment.

EPG Key:

Pressing the EPG key in analogue mode will display the Channel
Lock Menu.

Menu Lock:

You can set the menu lock NO and YES with this option. With
menu lock YES, the user must enter a password before any of the
programming menus are displayed.

Channel Lock:

To lock the current channel from unauthorised access, enter the
password to switch the channel lock from NO to YES.
(The factory password is 0000. To change the password, see the
Installation menu).
Note: the Channel lock is ineffective unless the receiver’s menus
are also locked. This prevents the unauthorised user from re-
tuning the restricted channel onto a different channel. To enable
menu lock, see the Installation menu.

Password:

Enter your password for your channel and menu locks. The default
password is 0000.

SYSTEM P001

LNB INPUT

LOCAL OSC.

UNI-HI

LNB PWR

14V

22KHz

OFF

0/12V

DECODER

OFF

COPY

001->001

UP/DN, LR, 0-9, OK, ESC, MEN

DISEQC P001

SATPOSITION A
SWITCHOPTION 1
DISEQC OFF

UP/DN, LEFT/RIGHT, OK, ESC

CH LOCK P001

MENULOCK NO
CHLOCK NO
PASSWORD 0000

UP/DN, LR, 0-9, OK, ESC, MEN