Sima Products Sima SUR-47 - Manual (Page 38)

Accessories SUR-47 User’s Manual
34
Appendix B - Accessories
PC Interface Kit – SUR-PC
The SUR-PC is an optional link cable that enables transmission of system setup to a personal computer or
another SUR-47. The following information can be transferred using the TRANS selection in the setup menus:
• PROGRAM – MCU Program
• PRE-CODE – Preprogrammed Code only
• MEMORY – All Flash Memory Data (Pre-programmed Codes included)
Please refer to the SUR-PC manual for instructions on using the cable.
IR Blaster Cable – SUR-IR
The IR Blaster Cable is an optional 6 ft. cable with an IR emitter on one end. It enables the base unit to send
signals to a device that would not be within its normal directional range. A device can be operated by aiming
the cable at the device or placing it directly onto the device.
Additional RF Base Unit – SUR-BU
The RF Base Unit receives the RF signal sent by the SUR-47and then sends the
appropriate IR signal to the desired device. The SUR-BU should be aimed at the
equipment you want to operate. It has 10 RF address settings that correspond
to settings selected in the SUR-47. Additional base units can be placed throughout
the house.