SATO MB200/201i - Manual (Page 38)

Operation and Configuration
3-8
Optional LCD screen (cont’d)
Two-line text display: Displays the following:
1) Various status messages: Firmware version,
Online mode, Offline mode, labels remaining in
print queue, Test Print status, Default Setting,
Complete, Factory Clear, Press Feed Key, Press
Print Key, Hex Dump Mode, Set up Display, Adjust
LCD, Exit, Contrast, Back Light On
2) Warning messages: Cover Open, Paper End,
Sensor Error, Buffer Near Full, Head Protect, Head
Error, Module Error,
3) WLAN information: Messages such as Adhoc
mode, Infrastructure mode, IP address, subnet
mask, default gateway, Socket Port Number.
Adjusting Display Contrast
To adjust the contrast of the LCD, go into
Maintenance mode. Use the FEED button to select
options, and the PRINT button to confirm a selection.
Now select the “Adjust LCD” option and then the
Contrast “option”. Values cycle between 30 and 63.
MB20xi A6.book Page 8 Friday, May 27, 2005 5:12 PM