SATO MB200/201i - Manual (Page 28)

Setup
2-14
Installing the label roll (cont’d)
For operating in the Dispense mode, the
following label loading procedures apply.
1. Make sure you can see the
red platen roller. If not, slide
the dispenser unit down, by
lifting its top edge upwards
at the two arrow marks.
Now push the dark gray
Cover Open/Close lever
downwards to release the
cover.
2. Peel the first label on the
top of the label. This step is
unnecessary when a non-
separate label is used.
Dispenser
unit
MB20xi A6.book Page 14 Friday, May 27, 2005 5:12 PM