Swisher ZT2460 - Manual (Page 21)

21
SERVICE & ADJUSTMENTS
¾ Push out on the Deck Lift Handle and raise or lower the deck to the desired
position.
¾ Position 1 is the lowest setting and Position 8 is the highest position
¾ The cutting range is from approximately 1 ½” to approximately 5”
Adjusting The Cutting Height
TOOLS REQUIRED:
9 2 - ½” Wrenches or ½” Socket with drive ratchet
¾ Lower the cutting deck down to the lowest position (position 1)
¾ Loosen the nuts on the top side of the deck hanger brackets (3 places) where the
lift cables attach to.
¾ With all three loose on top of the brackets the deck should now set on the ground
resting on the roller wheels.
¾ Tighten the nuts on the top of the lift brackets making sure that all three lift cables
are pulled tight.
¾ Lift deck using the deck lift handle to the desired position
Deck Leveling